ansible / ansible.builtin / v2.4.6.0-1 / module / vyos_l3_interface Manage L3 interfaces on VyOS network devices | "added in version" 2.4 of ansible.builtin" Authors: Ricardo Carrillo Cruz (@rcarrillocruz) preview | supported by networkansible.builtin.vyos_l3_interface (v2.4.6.0-1) — module
pip
Install with pip install ansible==2.4.6.0.post1
This module provides declarative management of L3 interfaces on VyOS network devices.
- name: Set eth0 IPv4 address vyos_l3_interface: name: eth0 ipv4: 192.168.0.1/24
- name: Remove eth0 IPv4 address vyos_l3_interface: name: eth0 state: absent
- name: Set IP addresses on aggregate vyos_l3_interface: aggregate: - { name: eth1, ipv4: 192.168.2.10/24 } - { name: eth2, ipv4: 192.168.3.10/24, ipv6: "fd5d:12c9:2201:1::1/64" }
- name: Remove IP addresses on aggregate vyos_l3_interface: aggregate: - { name: eth1, ipv4: 192.168.2.10/24 } - { name: eth2, ipv4: 192.168.3.10/24, ipv6: "fd5d:12c9:2201:1::1/64" } state: absent
ipv4: description: - IPv4 of the L3 interface. ipv6: description: - IPv6 of the L3 interface. name: description: - Name of the L3 interface. state: choices: - present - absent default: present description: - State of the L3 interface configuration. aggregate: description: List of L3 interfaces definitions
commands: description: The list of configuration mode commands to send to the device returned: always, except for the platforms that use Netconf transport to manage the device. sample: - set interfaces ethernet eth0 address '192.168.0.1/24' type: list