ansible / ansible.builtin / v2.8.11 / module / onyx_interface Manage Interfaces on Mellanox ONYX network devices | "added in version" 2.5 of ansible.builtin" Authors: Samer Deeb (@samerd) preview | supported by communityansible.builtin.onyx_interface (v2.8.11) — module
pip
Install with pip install ansible==2.8.11
This module provides declarative management of Interfaces on Mellanox ONYX network devices.
- name: configure interface onyx_interface: name: Eth1/2 description: test-interface speed: 100G mtu: 512
- name: make interface up onyx_interface: name: Eth1/2 enabled: True
- name: make interface down onyx_interface: name: Eth1/2 enabled: False
- name: Check intent arguments onyx_interface: name: Eth1/2 state: up
- name: Config + intent onyx_interface: name: Eth1/2 enabled: False state: down
mtu: description: - Maximum size of transmit packet. name: description: - Name of the Interface. required: true delay: default: 10 description: - Time in seconds to wait before checking for the operational state on remote device. This wait is applicable for operational state argument which are I(state) with values C(up)/C(down). purge: default: false description: - Purge Interfaces not defined in the aggregate parameter. This applies only for logical interface. type: bool speed: choices: - 1G - 10G - 25G - 40G - 50G - 56G - 100G description: - Interface link speed. state: choices: - present - absent - up - down default: present description: - State of the Interface configuration, C(up) means present and operationally up and C(down) means present and operationally C(down) duplex: choices: - full - half - auto default: auto description: - Interface link status enabled: description: - Interface link status. type: bool rx_rate: description: - Receiver rate in bits per second (bps). - This is state check parameter only. - Supports conditionals, see L(Conditionals in Networking Modules,../network/user_guide/network_working_with_command_output.html) tx_rate: description: - Transmit rate in bits per second (bps). - This is state check parameter only. - Supports conditionals, see L(Conditionals in Networking Modules,../network/user_guide/network_working_with_command_output.html) aggregate: description: List of Interfaces definitions. description: description: - Description of Interface.
commands: description: The list of configuration mode commands to send to the device. returned: always sample: - interface ethernet 1/2 - description test-interface - mtu 512 - exit type: list