extreme.exos.exos_command (0.1.1) — module

Install collection

Install with ansible-galaxy collection install extreme.exos:==0.1.1

Add to requirements.yml

  collections:
    - name: extreme.exos
      version: 0.1.1

Description

Sends arbitrary commands to an Extreme EXOS device and returns the results read from the device. This module includes an argument that will cause the module to wait for a specific condition before returning or timing out if the condition is not met.

This module does not support running configuration commands. Please use M(exos_config) to configure EXOS devices.

Inputs

    
match:
    choices:
    - any
    - all
    default: all
    description:
    - The I(match) argument is used in conjunction with the I(wait_for) argument to specify
      the match policy.  Valid values are C(all) or C(any).  If the value is set to C(all)
      then all conditionals in the wait_for must be satisfied.  If the value is set to
      C(any) then only one of the values must be satisfied.

retries:
    default: 10
    description:
    - Specifies the number of retries a command should by tried before it is considered
      failed. The command is run on the target device every retry and evaluated against
      the I(wait_for) conditions.

commands:
    description:
    - List of commands to send to the remote EXOS device over the configured provider.
      The resulting output from the command is returned. If the I(wait_for) argument is
      provided, the module is not returned until the condition is satisfied or the number
      of retries has expired.
    required: true

interval:
    default: 1
    description:
    - Configures the interval in seconds to wait between retries of the command. If the
      command does not pass the specified conditions, the interval indicates how long
      to wait before trying the command again.

wait_for:
    description:
    - List of conditions to evaluate against the output of the command. The task will
      wait for each condition to be true before moving forward. If the conditional is
      not true within the configured number of retries, the task fails. See examples.

Outputs

failed_conditions:
  description: The list of conditionals that have failed
  returned: failed
  sample:
  - '...'
  - '...'
  type: list
stdout:
  description: The set of responses from the commands
  returned: always apart from low level errors (such as action plugin)
  sample:
  - '...'
  - '...'
  type: list
stdout_lines:
  description: The value of stdout split into a list
  returned: always apart from low level errors (such as action plugin)
  sample:
  - - '...'
    - '...'
  - - '...'
  - - '...'
  type: list